Medline High / Low Control Solution for EVENCARE G2 Meters

The purpose of the control solution testing is to make sure the EVENCARE G2 Meter and the EVENCARE G2

Test Strips are working properly

You should perform a control solution test when:

• Using the meter for the first time
• Using a new bottle of EVENCARE G2 Blood Glucose Test Strips
• You left the test strip bottle cap open for awhile
• You dropped the meter
• You suspect your meter and test strips are not working properly
• The blood glucose test results do not reflect how you feel
• You want to practice the testing procedure

IMPORTANT

• Use only the EVENCARE G2 Glucose Control Solutions with the EVENCARE G2 Test Strips Other brands of control solution will produce inaccurate results
• Always check the expiration date DO NOT use control solutions if they are expired
• DO NOT FREEZE Store the control solutions at room temperature

MATERIALS NEEDED:

• EVENCARE G2 Control Solution (Low and High)
• Your EVENCARE G2 Meter
• A new EVENCARE G2 Blood Glucose Test Strip

Step 1. Take out an EVENCARE G2 Test Strip from the test strip bottle and close the bottle immediately Insert the test strip to turn on the meter

IMPORTANT

• Check the expiration date printed on the test strip bottle
• Do not use expired test strips
• Use each test strip immediately after removing it from the bottle
• Do not use wet or damaged test strips
• Keep test strips away from direct sunlight and heat
• Store the test strip bottle in a dry, cool place
• Record the “date opened” on the bottle label Discard the bottle and any remaining test strip after 6 months from date of opening
• Test within the temperature range of 50 ̊F to 104 ̊F Your meter will not work

Insert the test strip properly

• The flashing blood drop icon will appear once the test strip has been fully inserted

Step 2. Wait until the flashing blood drop and arrow icons appear on the meter display screen The meter will also announce, “Please apply blood onto the test strip” if you have the voice feature turned on Press ▼ one time to enter L1 (LOW) control solution testing

Step 3. ctl icon will appear next to the test strip icon and L1 will appear on the meter display screen The meter will also announce “L1 control solution test, please apply control solution onto the test strip ” If you decide not to do a control solution test, press ▼ two times and ctl will disappear from the meter display

Step 4. Squeeze a drop of Low control solution onto a clean, dry, non-absorbent surface Do not apply control solution to the test strip directly from the control solution bottle Replace the bottle cap on the control solution bottle immediately after use.